Genuine Everydrop Filter 2 EDR2RXD1 by Whirlpool (Orange) – Replaces W10413645A & Kenmore 9082 – NSF 401/53 Certified OEM

Product Overview

Upgrade your family’s hydration with the Genuine Everydrop® Filter 2, the only OEM replacement certified by Whirlpool for their bottom-freezer and French-door refrigerators. Easily recognized by its Orange Cap, this advanced filter goes beyond basic carbon filtration. It is engineered with Triple Filtration Technology to reduce 28 specific contaminants, including lead, pesticides, and industrial chemicals.

Unlike standard generic filters, the EDR2RXD1 is NSF 401 Certified to remove emerging threats like trace pharmaceuticals (such as Atenolol and Trimethoprim) often found in municipal water supplies. As the direct factory upgrade for discontinued part numbers W10413645A and Kenmore 9082, it guarantees a perfect, leak-free seal for your KitchenAid, Maytag, JennAir, or Amana appliance.

Key Features

• NSF/ANSI 42 & 53 certified for aesthetic and health-related contaminant reduction.
• Filters a wide range of contaminants, including lead, 2,4-D, asbestos, benzene, cysts, turbidity, and more.
• Replaces up to 1,500 plastic bottles over its 6-month lifespan (~200 gallons).
• Simple push-in installation—no tools required.
• Micron rating: approximately 0.5 to <1.0 µm.
• Triple-Layer Contaminant Reduction
• NSF 401 Pharmaceutical Grade
• Universal “Purple” Identification
• Legacy Part Compatibility
• Optimized Flow Rate
• 6-Month Lifespan

How It Works

Water flows through a carbon-based media that mechanically removes particulates and chemically captures contaminants like lead and benzene, providing clean, safe drinking water and ice.

Installation Instructions

• Locate the filter housing in the upper right-hand corner of your refrigerator ceiling or the bottom base grille, depending on your Whirlpool, Maytag, or KitchenAid model.

• Lift the compartment door upward to automatically release the old cartridge, then pull the used water filter straight out to discard it.

• Remove the purple protective cap from the new unit, ensuring the black rubber O-rings remain correctly seated on the nozzles to prevent future leaks.

• Align the arrow on the label pointing upward and gently slide the EDR1RXD1 replacement into the slot; it should glide smoothly without force.

• Push the filter inward until the door begins to close, then press the door firmly until it snaps shut to strictly lock the watertight seal.

• Flush the water dispenser for 4 gallons (approx. 5 minutes) to purge trapped air and remove loose carbon fines that cause cloudy water.

• Reset the filter status light on your control panel by holding the “Water Filter” or “Reset” button for 3 seconds to restart your 6-month maintenance cycle.

Compatibility & Cross-References

Enter your model or reference code below to find a match. Table includes known equivalents and compatible refrigerator model codes.